Model T Ford Chassis boxing plates (Based off of a 1926 - 1927 frame) but will fit all Model T frames for cars or trucks When building a street rod, throwing a modern day V8 motor in older day cars and driving the higher speeds that we drive today, boxing in the original flimsy frames is a must. Our Easy Weld boxing plates are cut undersized so that they would basically slip inside the original frame rails, to allow for a V gap for great weld penetration, without the worry of grinding away too much weld and sacrificing strength when grinding the welds flush. There are steps or outward notches incorporated into our boxing plates to prevent them from slipping inside the frame and making fitting and adjusting difficult.
Steel to give added strength when welding motor mounts, crossmembers and etc to the inside of the chassis. The two (per side) longer pieces run from the rear of the frame (in front of the gusset in the rear), right up to the front.The smaller pieces include 2 - 3" gussets and some 2" material (you cut to fit) to finish out the rear. You can choose to add the gusset below the existing gusset in the rear and then finish boxing on the outside or inside of the gussets (with the 2 material), which ever suits your taste. Some assembly, fitting and welding is required. Just a few of our feedback for our boxing plates. Nice product excellent ebayer A + NICE PARTS!!! Great product at a good price. The item "Model T Ford Frame, 1/8 Easy Weld Boxing Plates 26-27" is in sale since Thursday, June 17, 2010. This item is in the category "eBay Motors\Parts & Accessories\Vintage Car & Truck Parts\Other Parts". The seller is "wolfesmetalfabrication" and is located in Bradshaw, Nebraska.
This item can be shipped to United States, all countries in Europe, Canada, Japan.
134" or about 1/8"