Some lips re-uses the factory hardware or only double-sided tape. Like almost all aftermarket polyurethane lip kits, YES, you will need to drill holes. 3M Industrial Double-sided Tape is NOT Included, but is. Easy installation with basic hand-tools.
GENERAL POLYURETHANE BUMPER LIP / SPOILER INSTALLATION GUIDE for your reference only. Pre-fit all pieces to the vehicle prior to installation!! We highly recommend using masking tape anywhere the aero kit may be touching the vehicle body to prevent scratches during the pre-fit.
Do any sanding, filing, or spacing necessary (before painting) for a clean tight fit. Spending the extra time now will assure you of a perfect installation.
Clean the whole bumper lip with soap. Using the clean duster cloth to wipe up the surface of the product with thinner, then, use the duster cloth to wipe up the product again. Sand down the inner edges of the bumper lip with sand paper where you would apply the 3M double-sided tape, then, rinse it again.Without proper cleaning and sanding, 3M double-sided tape will not stick. The inner surface of the bumper lip has to be CLEAN and DRY for the tape to properly adhere. A residual-free cleaner is recommended to prepare the surface. The surface of the vehicle should also be prepped and cleaned for proper adhesion. For BEST results after cleaning, use of an adhesion promoter such as 3M should be applied to wherever tape will be used. After the bumper lip is mounted on the bumper with the double-sided tape, heat up the whole lip with a heat gun or hair blow dryer.
Not only because the heat will soften the polyurethane material and make the bumper lip mold to the shape of the bumper even better, it will also help the double-sided tape bound better. Repeat heating process a few times to make sure the fitment is at its best. At last, use two self-tapping screws on each side of the bumper by the wheel walls to extra secure the bumper lip on to the bumper.
Enjoy your new bumper lip kit. WE WILL NOT BE RESPONSIBLE FOR BUMPER LIPS THAT FELL OFF DUE TO INSTALLATION ERRORS. MagicDrift Lip Kit Splitter Supporting Rods. If by any chance the lip becomes distorted upon arrival, simply put the bumper lip back inside the plastic bag that it came with and lay it on a flat surface under the sun for a couple of hours. Or use a heat gun to gently heat up the distorted area and twist it in to the correct shape by hand.Under conditions of high pressure and temperature, parts can become distorted. The polyurethane material is bend-friendly can be adjusted back to its original shape when heated and stays that way after it cools down, repeat process if necessary. USA Domestic 48 States (Ground). PR, HI, AK, GU, VI, APO, FPO, PO BOX. Bulk quantities of 10 units or more.
Customer service is the most important to us. We do our very best to please every customers we have and look forward to dealing with future customers.We also reserve the right to refuse service to any unreasonable customers. Orders with insufficient payments will be placed on hold until buyers complete the full amount.
WE LOVE ALL OF OUR CUSTOMERS THEREFORE.. We will really appreciate if our customers can leave 5-star A+ feedback comment after receiving the product.We will make it right! We offer additional discounts for bulk quantities. Powered by SixBit's eCommerce Solution. The item "07-09 Mazda 3 Mazda3 4-Door Sedan Speed S-Model MS Front Bumper Lip (Urethane)" is in sale since Friday, October 12, 2012.
This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Exterior\Body Kits". The seller is "magicdrift_aerodynamics" and is located in Baldwin Park, California. This item can be shipped worldwide.